Audio Pro Stereo Zero Istruzioni per gli Interventi

1(ENG) OPERATING INSTRUCTIONSStereo Zero

10Connecting the speakersConnect speaker cables according to the drawing below. Speaker cables are normally marked + and - (or with different marks).

11INSTALLATIONUsing the remote controlInsert the AAA batteries included in the packaging into the battery opening on the back of the remote control. M

12CD FUNCTIONSPlayback a CDPress EJECT to open the CD tray. Place a CD in the tray with the label facing up. Press EJECT to close the tray. Press PLAY

13TUNER FUNCTIONSAutomatic search of FM/AM radio stationsSelect FM/AM as source using the SOURCE button. Select FM-stereo, FM-mono or AM with the FM/A

14RDS [RADIO DATA SYSTEM] FUNCTIONSUsing RDS (Europe only)The following RDS functions are available on this unit (in the following order):PS (Program

15ADJUSTING THE SOUNDAdjusting the volumeTurn the volume knob clockwise (to the right) to raise the volume or counter-clockwise (to the left) to lower

16OTHER IMPORTANT INFORMATION Connecting the headphones.Connect the headphones with a 3.5 mm [1/8 inch] ste-reo plug to the HEADPHONES output on the s

17TROUBLESHOOTINGIf a unit does not function or perform as expected, the problem is not always a mechanical one. The solution may be found in the tabl

18TECHNICAL DATAAudio section: Output power: RMS: 20Hz-20kHz < 0,7% THD, 8 Ω...2 x 40 W 20Hz-20kHz < 0,7%

19

2

20YOUR OWN NOTES:

21

Audio Pro ABBox 1015S-251 10 HelsingborgSwedenwww.audiopro.com

3CONTENTS4 Before connecting to power source 5 Security 6 Controls and indicators 6 The front panel 7 The remote control 8 Connections on the rear

4BEFORE CONNECTING TO POWER SOURCEUnpackingCarefully unpack the unit, making sure that all the accessories are included in the packaging (see below).

5Power sourceThis unit is intended for use with a 230 V AC power sup-ply only. Connecting to a different power source may lead to accidents or fire an

61) Power switchPress this button to turn on the receiver, assuming that it is in standby mode (the indicator LED on the front panel is red). If it is

7CONTROLS AND INDICATORSREMOTE CONTROL1) Remote function indicatorThis LED is lit during any operation made on the re-mote control.2) Power switchPres

8CONTROLS AND INDICATORSRear panel1) Connecting the FM indoor antenna Connect the enclosed FM indoor antenna. Locate the wire where the reception will

9CONTROLS AND INDICATORSSide panel1231) Line IN Connect your iPod, Mp3 player or any other audio source using a 3,5 mm audio cable.Select SIDE as sour